|
Dry mounting build-in element for wall toilet with build-in toilet cistern with frontal activation,
build-in height 1150 mm. It is intended for installation into prefabricated walls, as a
free-standing element for pre-wall installation in dry mounting, for pre-wall angle installation,
and for universal massive installation with in-wall installation.
Element consists of:
-
prefabricated supporting frame coated with blue lacquer with width of 200 mm
-
toilet cistern cisterns DUO with dual flushing. If the START – STOP button
is installed works with single flush START – STOP technique.
• High capacity: 6 or 9 l, factory default settings 9 l
• Low quantity: 3 or 4.5 l
-
moisture insulation with styrofoam pads installed in toilet cistern
-
two console supporting legs for installation on existing floor
adjustable by height (0 – 240 mm)
-
galvanized supporting frames for pre-wall installation adjustable by depth 150 - 220mm
-
two threaded rods with nuts M12 for fixing suspended toilet with
axial distance of 180 or 230mm
-
pre-assembled angle valve 1/2'' on the right side of the lid
-
build-in protection for box culvert
-
pre-installed PE wall discharge elbow Ø 90/
Ø 110 × 165 mm
-
Ø 90 mm collar sets
-
fixing material
-
without flushing plates
-
factory default settings of toilet cistern is
9 l and is changed only with regulation of discharge valve for
big quantity 6 or 9l, small quantity 3-4,5l is not regulated.
-
fill valve must remain at factory default setting!
Technical
data:
Spare parts:
 |
