Dry mounting build-in element »JOG« - S.V. Free-standing
low,
build-in height 1150mm. It is intended for installation in pre-wall partition walls as
a free-standing self-supporting element, or as a free-standing self-supporting element
between separating walls. It is used for the installation of wall toilet ceramics.
The element is always fixed to the floor.
Element consists of:
-
prefabricated supporting frame coated with blue lacquer with width of 200 mm
-
flushing cisterns DUO with dual flushing. If the START – STOP button is
installed works with single flush START – STOP technique.
*High capacity: 6 or 9 l, factory default settings 9 l
*Low quantity: 3 or 4.5 l
-
moisture insulation with styrofoam pads installed in toilet cistern
-
two console supporting legs for installation on existing floor adjustable by height (0 – 240 mm)
-
two threaded rods with nuts M12 for fixing toilet with axial distance of 180 or 230mm
-
pre-installed angle valve 1/2'' on the right side of the lid
-
build-in protection for box culvert
-
pre-installed PE wall discharge elbow ø 90/ ø 100 with gaskets
-
fixing material
-
without flushing plates
-
factory default of toilet cistern is 9 litres and can only be changed
by regulating discharge valve for the quantity of 9 or 6 litres. The lower quantity is NOT changed.
-
fill valve must remain at factory default setting!
